The permanent base station is now installed and located-it has internet by connecting to our Wifi network.

The location of the permanent base station was then verified by switching the it to base mode and surveying two other known points with our second Emlid Reach as the rover. Instead, the location of the permanent base station was established by first setting up a temporary base station over a known point and allowing the permanent base station to act as a rover, gathering corrections from the temporary base station. The (now permanent) base station is not setup over a known point. I think I'm using option 2 that you have outlined above. Moving forward, we would like the option to use the Trimble R10 as our rover. The initial location establishment (described more below) was completed utilizing a second Emlid Reach, often toggling the two units between base and rover. A couple notes.The base station is an Emlid Reach. Thanks for the thoughtful response! Unsurprisingly, some of my language is likely incorrect, which caused some confusion (but I'll do my best). It might clear things up a bit (for me) if you state which of the following you’re doing or maybe elaborate a bit more on what your base station is, what modem you’re using etc.ĭo you only have an R10 and are using NTRIP to get corrections from a CORS network?Īre you setting up a base station over a known point or arbitrarily and using it, a modem and an NTRIP caster software to send the corrections to rtk2go and then trying to receive the corrections via rtk2go using NTRIP either through the receiver, controller or external device?Īre you just hooking into some random base station you’re finding on rtk2go ?

it’s designed to receive and distribute corrections which is why I’m not really understanding your comment either so sorry if I haven’t picked up on something glaringly obvious you’ve said. I visited the website for rtk2go and it reads like it’s a host (server), not a caster or client i.e. I do however use an SPS985 with Lefebure NTRIP client to receive corrections from a CORS Network.

Hey mate, I don’t use a Trimble receiver/base with rtk2go.

Ntrip caster software